ASTM C1103-14 Historical

1887972

Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines

standard by ASTM International , 11/15/2014

This standard is not available for sale.
Track This

Full Description

1.1 This practice covers procedures for testing the joints of installed precast concrete pipe sewer lines, when using either air or water under low pressure to demonstrate the integrity of the joint and the construction procedures. This practice is used for testing 27-in. and larger diameter precast concrete sewer lines utilizing rubber gasket sealed joints.

Note 1: The user of this practice is advised that methods described herein may also be used as a preliminary test to enable the manufacturer or installer to demonstrate the condition of sewer pipe prior to delivery.

1.2 This practice is the inch-pound companion to Practice C1103M; therefore, no SI equivalents are presented in the practice.

Note 2: The owner shall specify the following: who will conduct, observe, and furnish labor, material, and measuring devices and pay for the tests; who is responsible for determining local ground conditions; and whether an air or water test is to be used.

Note 3: The user of this practice is advised that test criteria presented in this practice are similar to those in general use. Pipe shall be accepted by infiltration or exfiltration testing utilizing Practice C969.

Note 4: Test times tabulated and the rate of air loss in this practice are based on successful testing of installed pipelines. However, since air and water have different physical properties, retests of some pipelines not meeting field air tests have been successful when tested with water.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautions are given in Section 6.

See more

Also Bought By Customers

 

Document History

  1. ASTM C1103-22


    Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines

    • Most Recent

  2. ASTM C1103-19


    Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines

    • Historical Version

  3. ASTM C1103-14

    👀 currently
    viewing


    Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines

    • Historical Version

  4. ASTM C1103-03(2009)


    Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines

    • Historical Version

  5. ASTM C1103-03


    Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines

    • Historical Version

  6. ASTM C1103-02


    Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines

    • Historical Version

  7. ASTM C1103-94(2000)


    Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines

    • Historical Version

Order Options

Unavailable

Product Details

Published:

11/15/2014

Number of Pages:

2

Note:

This product is restricted and cannot be purchased in these countries.