BS EN 61000-4-3:2006+A2:2010 Historical

BS EN 61000-4-3:2006+A2:2010 is applicable to the immunity requirements of electrical and electronic equipment to radiated electromagnetic energy. It establishes test levels and the required test procedures.

The object of BS EN 61000-4-3:2006+A2:2010 is to establish a common reference for evaluating the immunity of electrical and electronic equipment when subjected to radiated, radio-frequency electromagnetic fields. The test method documented in this part of IEC 61000 describes a consistent method to assess the immunity of an equipment or system against a defined phenomenon.

NOTE 1 As described in IEC Guide 107, this is a basic EMC publication for use by product committees of the IEC.

As also stated in Guide 107, the IEC product committees are responsible for determining whether this immunity test standard should be applied or not, and if applied, they are responsible for determining the appropriate test levels and performance criteria. TC 77 and its sub-committees are prepared to co-operate with product committees in the evaluation of the value of particular immunity tests for their products.

This part deals with immunity tests related to the protection against RF electromagnetic fields from any source.

Particular considerations are devoted to the protection against radio-frequency emissions from digital radiotelephones and other RF emitting devices.

NOTE 2 Test methods are defined in this part for evaluating the effect that electromagnetic radiation has on the equipment concerned. The simulation and measurement of electromagnetic radiation is not adequately exact for quantitative determination of effects. The test methods defined are structured for the primary objective of establishing adequate repeatability of results at various test facilities for qualitative analysis of effects.

BS EN 61000-4-3:2006+A2:2010 is an independent test method. Other test methods may not be used as substitutes for claiming compliance with this standard.



Cross References:
IEC 60050-161
IEC 61000-4-6
IEEE 1309
ISO/IEC Guide 98-3:2008
GUM:1995


Incorporates the following:
Amendment, May 2008. Amends and replaces BS EN 61000-4-3:2006. Corrigendum, October 2009. Amendment, August 2010. Amends and replaces BS EN 61000-4-3:2006+A1:2008 which remains current